Learning to start small in Cabri3D

Felix Grant — Tue, 22 May 2007 23:47:25 +0000

I was interested in AbsentCat’s Active Geometry post, talking of a “geometry processor” doing wonderful things, but learning to use it sounded too much to cope with in the endless pressure of a school day. I work with young teenagers who should be in early Key Stage Four, but, because their previous education has been disrupted by events beyond their control or a teacher’s capacity to imagine, are in most cases struggling to master KS2 or even KS1. How could this active geometry business help them or me? But, during a staff development workshop, I was shown the ready made examples accompanying a copy of the three dimensional version, Cabri3D, mentioned by Philip Yorke. One of them addressed a topic which I was due to tackle with my youngsters: the nets of a solid. When I expressed interest in that example, I was offered a short loan of the laptop on which the workshop demonstration had been run.

Very uncertainly, I rigged up the machine and waited for my class. And they loved it. They are very videogame savvy, and related to the direct manipulation of an onscreen object in a way they had never related to paper or cardboard equivalents. The software allows them to pick up a single section of the flattened net, swing it along a guide path, and have the attached panels follow it. The cube assembles itself. Then a face can be swung back, restoring the 3D solid to flat net. As many times as they wish. With the ice broken, they were then amenable to physical exploration in a way that they had never been before.

Since then, I have read Chandra’s account of her Beanbag Thrower - another example of starting small, with a simple and manageable aspect, not being overawed by the greater power available. I have learned a lot from the experience, and learned a lot too from her account. Next time, I shall be bolder - integrating the software into a lesson plan, as she has, rather than just starting with it. I have borrowed the demonstration machine again, and next week I shall be using the 2D version, Cabri II Plus, for a more ambitious project around bicycle wheels. I intend to watch the demonstration videos, have signed up for another workshop on geometric software in CDT, and plan to spend the summer reinventing myself - bring it on.

[contributed by BobTheBumbler]

Scientific Computing World: Education » CDT

Learning to start small in Cabri3D